9/10/2023 0 Comments Timber framer iron mineIn your case, you need to see that those joists are well supported the studs braced & this extra load supported. Then reinforce the studs with noggins between screwed to this bearer.Īs a young engineer, I was counselled by our structual tutor "If it looks right, it probably is right". In my address I advised that President Cde E.D. To remedy your dilemma, I would rip them out & turn them vertical & attach with joist hangers.Īs to better support of the joists, if you are able, look to install a bearer below them & use something like simpson structural screws to attach to the studs. All these will do is brace the joists & not add any dead/live load capability. Those infill pieces look to be lumps of joist toe-nailed into the principal joists. Whilst not up to speed on bolting schedules - my inner engineer would use a pair of bolts spaced thirds across the stud & 50mm from top/bottom face. Steel beams or frames combined with cross-laminated timber panels 11,12 or with timber-frame shear walls 13,14 have been studied through experimental tests. No way should those joists be relying on a single bolt into a stud that is not braced. For intermediate joists, a bearing support is housed into the studs to take the floor load. This is a scenario seen with old school ballon framing, in which studs rose from sole plate to roof plate. Rather than using small framing members (2x4s, 2x8s, etc. Those joists are pretty meaty, so there's a lot going on out of shot. Well, I don't think much of your SE - IMHO. Timber framing is a specialized version of timber post and beam that is built like furniture, using wood joinery such as mortise and tenon, held in place with wooden pegs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |